1. 程式人生 > >How to use CAR FANS C800 Diagnostic Scan Tool to do diagnosis operation

How to use CAR FANS C800 Diagnostic Scan Tool to do diagnosis operation

ces person required pro tel fail del data per

How to use Heavy Duty Diagnostic CAR FANS C800 Diagnostic Scan Tool to do diagnosis operation

Here is the post of introducing how to use CAR FANS C800 Diagnostic Scan Tool to do diagnosis operation. The procedure is shown as below:

1. Enter the diagnostic system

You can select the corresponding vehicle type by selecting the display area on the left side of the main interface, and then select the brand, system and system function in the right model selection area to enter the diagnosis operation.
For example: After entering the main interface of the car diagnosis, you can: click on the “truck series” -> “SANY” -> “Yuchai engine”, and then select the diagnostic function you want to test diagnostic tests.

2. Start Diagnostic

After entering the system, the functions that can be implemented include: Identification/Read Fault code/Erase Fault code/Actual Values/Actuators
Advance Functions:Adjustment/Settings, Function Test, Special function, calibration etc.
Specific functions will be different according to different models of the brand and the system, take Bosch engine in Foton engine system as an example:

3. Identification

Identification is the vehicle and system information in ECU. When the vehicle control unit need to be replaced, it is necessary to read the original control unit information and record it as a reference for purchasing a new control unit. When the new control unit is encoded, the original control unit information is required.

4. Read Fault code

Read the fault code function can read ECU fault code to help maintenance personnel quickly found the cause of vehicle failure.

5. Erase Fault code

Clear the fault code stored in the ECU.

Note: General models, please follow the regular order, first read the fault code, and record (or print) and then clear the fault code, test, read the fault code again to verify, repair the vehicle, clear the fault code, test again to confirm the fault code The current hard fault code can not be cleared, if the oxygen sensor, knock sensor, mixed gas correction, cylinder fire and the like type of technical code can be removed immediately, but in a certain period will appear. Must be completely troubleshooting after the fault code will not appear again.

6. Actual Values

You can determine whether the various parts of the vehicle are faulty through actual values.
Method of operation:
1. After entering the diagnostic function, click “Actual values”, pop-up dialog box.
2. Click the “Select All” check box to select all actual values; you can also click the check box before each actual value to select the data stream you want to read.
3. Click the “Read actual values” button. The interface displays the name, result, and unit of the data stream.

7. Actuators

In order to test the electronic control system in the implementation of components can work properly.
Method of operation:
1. After entering the diagnostic function, select “Actuators”, the interface will display all the action can be tested.
2. Click on an item to enter the action test interface. The actuators include three states: open, close, and exit.
3. Click “Open”, the status of the action test is turned on.
4. Click “Close”, the status of the action test is off.
5. Click “Exit” to exit this action test.

8. Advanced Function

Advance Functions: Adjustment/Settings、Function Test、Special function, calibration.
For example: diesel fuel injector code, idle speed adjustment, broken cylinder test, calibration and so on.

See more click:http://www.autonumen.com/

How to use CAR FANS C800 Diagnostic Scan Tool to do diagnosis operation