Linux-2.6.32.2核心在mini2440上的移植(四)---根檔案系統製作(1)
阿新 • • 發佈：2019-01-26
ROMFS MTD (C) 2007 Red Hat, Inc.
msgmni has been set to 109
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Console: switching to colour frame b?r device 60x53
fb0: s3c2410fb frame b?r device
s3c2440- rt.0: s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2440
s3c2440- rt.1: s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2440
s3c2440- rt.2: s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2440
brd: module loaded
S3C24XX NAND Driver, (c) 2004 Simtec Electronics
s3c24xx-nand s3c2440-nand: Tacls=3, 29ns Twrph0=7 69ns, Twrph1=3 29ns
s3c24xx-nand s3c2440-nand: NAND soft ECC
NAND device: Man?turer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 5 MTD partitions on "NAND 128MiB 3,3V 8-bit":
0x000000000000-0x000000040000 : "boot"
0x000000040000-0x000000060000 : "param"
0x000000060000-0x000000560000 : "kernel"
0x000000560000-0x000008000000 : "rootfs"
0x000000000000-0x000008000000 : "nand"
dm9000 Ethernet Driver, V1.31
eth0: dm9000e at c486e300,c4872304 IRQ 51 MAC: 08:90:90:90:90:90 (chip)
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
usb usb1: configuration #1 chosen from 1 choice
h 1-0:1.0: USB h found
h 1-0:1.0: 2 ports detected
usbcore: registered new interface driver libus l
mice: PS/2 mouse device common for all mice
S3C24XX RTC, (c) 2004,2006 Simtec Electronics
i2c /dev entries driver
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
cpuidle: using governor ladder
sdhci: Secure Digital Host Controller Interface driver
sdhci: Copyright(c) Pierre Ossman
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.21.
No device for DAI A134X
No device for DAI s3c24xx-i2s
ALSA device list:
No soundcards found.
TCP c ic registered
NET: Registered protocol family 17
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
IP-Config: Complete:
device=eth0, addr=10.1.0.129, mask=255.255.255.0, gw=10.1.0.1,
host=10.1.0.129, domain=, nis-domain=(none),
bootserver=10.1.0.128, rootserver=10.1.0.128, rootpath=
Freeing init memory: 4828K
----------munt all----------------
***********************************************
************booting to mini2440 *****************
Kernel version:linux-2.6.32.2
the fans:singleboy
Date:2011.5.30
***********************************************
msgmni has been set to 109
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Console: switching to colour frame b?r device 60x53
fb0: s3c2410fb frame b?r device
s3c2440- rt.0: s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2440
s3c2440- rt.1: s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2440
s3c2440- rt.2: s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2440
brd: module loaded
S3C24XX NAND Driver, (c) 2004 Simtec Electronics
s3c24xx-nand s3c2440-nand: Tacls=3, 29ns Twrph0=7 69ns, Twrph1=3 29ns
s3c24xx-nand s3c2440-nand: NAND soft ECC
NAND device: Man?turer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 5 MTD partitions on "NAND 128MiB 3,3V 8-bit":
0x000000000000-0x000000040000 : "boot"
0x000000040000-0x000000060000 : "param"
0x000000060000-0x000000560000 : "kernel"
0x000000560000-0x000008000000 : "rootfs"
0x000000000000-0x000008000000 : "nand"
dm9000 Ethernet Driver, V1.31
eth0: dm9000e at c486e300,c4872304 IRQ 51 MAC: 08:90:90:90:90:90 (chip)
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
usb usb1: configuration #1 chosen from 1 choice
h 1-0:1.0: USB h found
h 1-0:1.0: 2 ports detected
usbcore: registered new interface driver libus l
mice: PS/2 mouse device common for all mice
S3C24XX RTC, (c) 2004,2006 Simtec Electronics
i2c /dev entries driver
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
cpuidle: using governor ladder
sdhci: Secure Digital Host Controller Interface driver
sdhci: Copyright(c) Pierre Ossman
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.21.
No device for DAI A134X
No device for DAI s3c24xx-i2s
ALSA device list:
No soundcards found.
TCP c ic registered
NET: Registered protocol family 17
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
IP-Config: Complete:
device=eth0, addr=10.1.0.129, mask=255.255.255.0, gw=10.1.0.1,
host=10.1.0.129, domain=, nis-domain=(none),
bootserver=10.1.0.128, rootserver=10.1.0.128, rootpath=
Freeing init memory: 4828K
----------munt all----------------
***********************************************
************booting to mini2440 *****************
Kernel version:linux-2.6.32.2
the fans:singleboy
Date:2011.5.30
***********************************************